Module 10: Tea and coffee · Lesson 65 of 79 · 5:33 · English

Milk steaming and simple latte art

Milk steaming and simple latte art - video lesson
Join the waiting list Log in Free. We create your login and email it to you. All 79 lessons included.

Transcript

0:00 Welcome to the chef course. In this video you will learn how to turn cold milk into silky microfoam with the steam wand, and how to pour a simple heart on top of a latte.
0:12 Most of a latte or a cappuccino is milk. Well steamed milk is sweet, glossy and silky, and we call it microfoam. Foam with big bubbles spoils both the taste and the look of the drink.
0:25 Always use cold, fresh milk straight from the fridge. Full-cream milk gives the best foam. The jug must be clean and cold. Fill it about one third, up to the base of the spout, because the milk expands when you steam it.
0:40 Before steaming, open the wand for a second or two to purge it. This clears the water that has collected inside the wand. Otherwise that water goes into the milk and makes it thin.
0:53 Place the tip of the wand just below the surface of the milk, and hold the jug slightly tilted. Keep your other hand on the side of the jug so you can feel the heat. Then open the steam fully.
1:06 The first part is stretching. Listen for a soft sound like paper tearing; that means air is going into the milk. Only a few seconds, while the jug is barely warm. A loud screech means the tip is too deep.
1:21 The second part is the whirlpool. Lift the jug a little so the tip goes deeper and the milk spins in a circle. Now no more air goes in. The milk only heats up, and the bubbles become fine and blend in.
1:35 Remember the card. Cold milk from the fridge, jug one third full, air only at the start while the milk is barely warm, and stop when the milk reaches 55 to 65 degrees Celsius. Never steam the same milk twice.
1:51 If you have no thermometer, use your hand. When your palm cannot stay on the jug for more than a second, stop the steam. Above 70 degrees Celsius the milk loses sweetness, and it can burn the guest's tongue.
2:05 The moment you stop the steam, wipe the wand with a damp, clean cloth and purge it for one second. Otherwise milk dries onto the wand and blocks the tiny holes inside. Keep a separate cloth for the wand only.
2:20 Now tap the jug gently on the counter to break the big bubbles, then swirl it round and round. When the milk shines like wet paint, it is ready. Do not wait, or the foam and the milk separate.
2:33 Latte art needs two things: a fresh espresso with good crema, and glossy microfoam. Experienced baristas say a good design comes mostly from good milk. The skill of the hand comes later, with practice.
2:49 The first step of the heart: tilt the cup towards you at about 45 degrees. Hold the jug about 5 centimetres up and pour a thin stream into the centre of the espresso. From that height the milk sinks under the crema.
3:04 When the cup is half to three quarters full, bring the spout of the jug close to the surface. Now the white foam rises and forms a round circle in the middle. Keep pouring in the same spot so the circle grows.
3:18 When the cup is nearly full, level it, lift the jug slightly, and draw the thin stream in a straight line through the middle of the circle. The circle becomes a heart. Do not stop, or the design sinks.
3:32 Your first hearts will be lopsided, and that is normal. Most mistakes are two: foam too thick or too thin, and a pouring speed that keeps changing. Practise every day, first the heart, then the rosetta, which is the leaf design.
3:49 For a rosetta, you wiggle the jug gently from side to side while drawing it back, and finish by pulling the stream through the middle. But master the heart first. A guest likes a clean heart more than a crooked rosetta.
4:03 The difference between a cappuccino and a latte is the foam. For a cappuccino, add more air so the foam is thick and tall. For a latte, add less air, a thin layer of about one centimetre, so the design pours easily.
4:19 Rinse the jug after every use, and throw away any leftover hot milk. Put the milk carton straight back into the fridge and check its expiry date. Milk left on a warm counter spoils quickly.
4:33 The steam wand and the jug get very hot. Always hold the jug by its handle, never touch the wand with a bare hand, and put the tip into the milk before you open the steam, so hot milk cannot splash you.
4:47 Place the latte so the heart faces the guest, with the handle towards the guest's right hand. A clean heart tells the guest that someone took care over this cup, and that is what they remember.
5:00 Give a new barista time to practise a few cups every day, and let the head barista watch and say what to fix in the milk or the pour. Within a few weeks, every cup has a clean heart.
5:12 Remember: cold milk, purge first, a little air then the whirlpool, stop at 55 to 65 degrees Celsius, and clean the wand at once. Then tap, swirl, pour into the centre, come in close and draw the heart. Thank you.